motorscooter - scooters for sale

With all the controls located on the handlebars and user-friendly instructions in clear sight, even less experienced operators, such as those encountered in the rental industry, can easily and safely operate the MPB16, he said. The buggy has a 16 cu.ft. load capacity, a polyethylene bucket (with a steel bucket available as an option) with a molded splash guard and a top-mounted, top-fill 13 gal. fuel tank, which allows all-day operation.Air-cooled Honda engines also have homes in the new Magnum MWT500 and MWT1000 water motorscooter trailers, which have 500 and 1000 gal. capacities, respectively. The units use a 2 in. Tsurumi centrifugal pump powered by a four-stroke Honda engine rated 4 hp. A 2 in. x 4 in. welded tubular steel flame fully supports a full steel cradle that supports a 3/8 in. thick polyethylene water tank. For convenience and efficiency, all engine, pump and valve controls are operable from the driver''s side of the trailer.

It''s great to be able to buy a nice, new, shiny piece of machinery, but that''s just not always possible. New skid steer attachments, depending on their function, can run up to $10,000 or more. Renting is one option to consider, especially when you only need the attachment for a short time.Farm auctions are another good source for attachments. "One definite trend I''ve picked up on over the past year has been the move to sell these attachments separately from the skid steer at auctions," says auction expert Greg Peterson, publisher of the F.A.C.T''s Report (800/381-0423 or machinerypete.com). His service reports machinery prices from auctions around the country.

Visually inspect the upper radiator hose for pressure marks and traces of rubbing at motorscooter the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced with the new style hose (See Parts Information).NOTE: A modified hose was used in production from approximately mid-November 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.